Forget the stepladder and get yourself a telescoping extension pole for your paint roller. Extension poles come in various lengths, up to 18 feet long, but one that extends from 18 to 36 inches is good enough to paint rooms with 8- to 9-foot-tall ceilings. Check that your paint roller's handle has a threaded hole in the end, then simply twist it onto the extension pole.
This job is usually done by a professional house painter. The painter will assess the walls, clean, and make any necessary repairs or removal of old wall coverings. They will also tape off any adjacent surfaces and cover nearby furniture and floors with drop cloths. Typically, they will apply a layer of primer, then one to three coats of paint, depending on the color and coverage. Once the paint is dry, they take a final walkthrough to inspect and make any necessary touch ups.
You are right on with this - why do people leave switch plates on when it's just so easy to take them off? Another thing that happened to us - we had the popcorn ceiling taken off and the ceiling painted white. When the job was done and I later went to change out all the fixtures/fans, they had left every fixture in place, so there was a large patch of popcorn and unpainted ceiling left behind - it just didn't dawn on me to specify that they take those down before scraping and painting. It was kind of a mess.
Oh, where to begin? Let me start with 'watered down paint'. 25-50% before the material gets to the site? Impossible. You would basically be painting with water at that point. It would be less of a hassle, and cost, to simply use proper material. You would be forced to apply three coats instead of two, as the coverage would be horrible. Whatever cost you think might be saved in materials would be lost in labor.
The secret to a finish that's free of lap and brush marks is mixing a paint extender (also called a paint conditioner), such as Floetrol, into the paint. This does two things. First, it slows down the paint drying time, giving you a longer window to overlap just-painted areas without getting ugly lap marks that happen when you paint over dried paint and darken the color. Second, paint extender levels out the paint so brush strokes are virtually eliminated (or at least much less obvious). Pros use extenders when painting drywall, woodwork, cabinets and doors. Manufacturer's directions tell you how much extender to add per gallon of paint.
Cleaning oil-based paints can be a challenge. Sometimes it’s best to let your tools dry and throw them away. However, if you plan on saving your tools you’ll need mineral spirits, paint thinner or lacquer thinner, a cleaning comb or brush and two metal containers or glass jars with lids. One container will be for clean solvent and the other for dirty solvent.
OF the different type of customers there are at least two: cheap charley's and people who want great results. I agree the need for wall repair is critical to the end results. Most critical is for the customer to be told ahead that the walls are going to need exactly what is needed. This means the contractor must look, touch, examine the walls for defects and needed work. I've been a building manager for 40 years and seen a few paint jobs. Typically a contractor does a lot of talking about how expert he is, but the guys who walk through with note pads, iPads, examine, measure, point things out, explain and recommend are the ones I will deal with. It confirms if they know what the business. Nobody likes the workers to show up and when you talk about the job they're going to do they know nothing but they we were told to be here. Their boss who bid the job doesn't supervise - a big no no around here. Nobody likes surprises or worse, at the end of a job that's not right getting a bunch of little kid excuses. Contractors that do not like the customer to be around looking at the progress don't get the job.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges
Third: The contractor buys the materials. We get them at a better rate and customers really don't know what they are getting into by being a material racer. Once again, I'm not referring to the guys that paint a bedroom or 2 a week. Tell the homeowner to go grab 50 gallons of paint, $300.00 worth of sundries and related job cost items and I'd be interested to see how it works for them....IT WILL NOT. And if were talking about people getting taken advantage of here, the paint suppliers with no relationship to a homeowner will 100% GOUGE the customer and completely take advantage of them with pricing. Contractors will pay nearly half the price and will still save the customers money marking up paint 10-15%.
Hi Patty, we are currently working on a manual for commercial bidding which we will provide once it’s completed. Most homeowners choose the middle bid believe it or not. Many companies think they have to be the lowest bid, but after setting up over 20,000 estimates, we’ve seen that the homeowner is often scared by the low bid, and thinks the high bid is too pricey. If your bid is in the middle and you present yourself professionally, you’ll have a much better chance of landing the job.
Sorry it is difficult to trust almost anyone in the trades. It is easier to do the work myself and not deal with strangers in and around my house. When I have to hire someone I tell them up front that I'll be checking every detail, pay extra to purchase the materials myself, and if they don't want the job - well good! I always fine someone who will work with me as I pay a bonus for that.
The size of the room to be painted is the most important factor in determining the cost of professional painting. It will take a painter longer to cover a large room than a small room, and this means higher labor costs in addition to supplies and time. When estimating the paint for such a job, keep in mind that a gallon of paint covers about 400 square feet (though the label claims it will cover 450 square feet). You will be charged for the number of paint cans needed, among other factors.