A special thanks to the employees of Warline as they were a very courteous and professional group of young men and women. Not one complaint was received from the owners during the two month process with all owners stating that they were very pleased with the outcome and the professionalism of all involved. The strata council of Hazelmere Village (South Surrey) have no hesitation in recommending Warren Nyline and his company as a painting contractor for your painting needs. A stress free job extremely well done.
Warline Painting is definitely a service quality company. We are extremely pleased with the interior painting work they did and have already recommended them to neighbours. The initial visit and orientation by Warren and Tyler was what sold us on choosing Warline as they explained everything about the process in detail so we knew what to expect. Their carpenter Jim was a surprise bonus as he repaired and improved a number of areas in our house that needed to be addressed before painting could begin and he did a wonderful job. The whole team was a joy to get to know. Thank you so much Warline for doing a terrific job!
Lastly, chose a sheen to match the needs of the space. Flat finishes hide imperfections well and absorb light which can make the paint look darker. Eggshells and satins are tough enough to be used in family rooms, kids' rooms, and hallways but don’t hide surface imperfection well. Semi-Gloss and high-gloss finishes are primarily used for trim because they accentuate woodwork details and clean up easily.
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
Professional paint crews know what they’re doing. Odds are, they’ve been in the business a while & can crank out a fully prepped room in just a matter of hours. Trim, however, is one of the most time-consuming portions of a room repaint (aside from prep). If you have a lot of trim/detail pieces in a room, keep in mind that this can affect how much it costs to paint.
Spray Option – $3,800 to $5,500. This package involves removal and spraying of all the doors, drawers, frames and boxes. It’s a good option for high quality existing kitchen cabinets and it’s the closest you can get to a factory finish. Spraying happens off the site, but on site painting can be arranged if the customer prefers it. We suggest installing new and upgraded hardware.
Considering the size of these rooms, one would assume that painting them is quite inexpensive. Sometimes it is inexpensive but more often than not, it is not the case. The reason is mostly because of the more detailed work in tight spaces. Painting around bathtubs, light fixtures and cabinets takes a lot of time and careful brushwork. Getting up close and personal with a stranger’s toilet and painting behind it takes a certain “je ne sais quoi”. In a laundry room the difficulty depends on how the washer and dryer are installed and if the painter needs to move them to access the walls behind them.
Unless you like textured walls, don't paint over dust. Wash the walls with trisodium phosphate (TSP) or a mild cleaner, like Jasco's TSP No-Rinse Substitute. For smoke-stained walls, Toto uses a 50/50 solution of bleach and water. To clean a wall, use two buckets. Load up your rag or sponge from your cleaning-solution bucket, and scrub. Before redipping, rinse the sponge in a second bucket filled with clean water.
The pros were split on this tip. "Masking tape is problematic," says Mark Dixon, a painter in Missoula, Montana, and author of "House Painting Inside and Out" (Taunton Press, 1997). "Paint can bleed behind the tape, or remove the paint it's stuck to." Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) On the other hand, "If you can't cut in, you can't beat tape," says Span. The pros we spoke with all recommend painter's (blue) tape because it's easier to remove than masking tape. To prevent bleeding, Span uses a putty knife to bed the tape. After letting the paint dry, he scores the edge of the tape line with a utility knife to avoid tearing the paint.
Prime. Dark colors, stains (once sealed), and previously unpainted surfaces (drywall, spackle, etc.) will need a primer coat, usually white. NOTE: most paint stores & home improvement centers will now tint primer (at no charge) to match fairly close to the color of the finished coat, that way two coats of primer need not be applied. Although not all surfaces need a prime coat, skip this step at your peril! Dark colors will likely show through the first -- or even the first couple-- topcoats of paint. Sealants and unpainted surfaces like spackle patches will absorb or repel moisture in a topcoat at a different level than the areas surrounding them. Applying a good primer coat will help even out these differences. Primer equalizes a wall to a uniform surface. It's like erasing a canvas before drawing a new picture. Although some will argue the point, you generally don't need to spend a great deal on primer or buy special primer. A cheap, 5 gallon (18.9 L) bucket of plain, flat white paint will usually do the trick and cover a large area. Give your primer at least 24 hours to dry (follow its instructions) before applying a topcoat.
Before your painter arrives, remove furniture, belongings, wall hangings and window treatments to make it easier for them to get right to work. Once they arrive, your pro will start preparing the inside of your house. Depending on the condition of your walls and the scope of your project, prep work could range from a simple dusting and washing to spackling, sanding, and minor drywall repairs. Your pro may also fill nail holes, caulk cracks around trim, scrape loose paint, skim coat uneven surfaces, mask trim or other surfaces, and apply a coat or two of primer that is suited to both existing and new paints.
Most pros don't bother cleaning brushes and rollers if they are going to use them the next day on the same job. "Latex paint dries slowly in cold temperatures," says Maceyunas. For two-day jobs, he wraps the rollers and brushes in plastic grocery bags and sticks them in the refrigerator. "Just allow the roller to return to room temperature before reusing it," he says. Roller covers are almost impossible to clean thoroughly. Most pros buy new covers for each job.