Basic labor to paint home with favorable site conditions. Prep up to 3 hr per 100 SF - clean, scrape, sand and patch up to 4 defects per 100 SF. Caulk gaps and spot prime. Roll / brush 2 coats of paint over lightly textured ceiling/walls. Paint up to 2 doors and door trim per room. Includes planning, equipment and material acquisition, area preparation and protection, setup and cleanup. 129 square feet $93.64 $126.68
A fellow (actually lives in the same neighborhood) by the name of Wayne Hickey (843-655-0366) painted the ceilings and most of the walls of our house in February 2017. He got paint all over my light fixtures, all over my trim around the doors, and had visible lap marks everywhere on the walls. He came back and rectified some of the problems, but not all, as I have noticed as I have had time to look more carefully at the work he and his assistant did. His assistant had no idea (not a clue) how to roll paint on a wall or ceiling. Some places were not covered. He said he would pull nails for pictures and then re-insert the nails exactly where they were. This he did not do as he promised. He painted over the nails. His assistant had no idea how to use a paint roller. I have painted all my life, and would have done this work myself, but I just had a full knee replacement and the other knee is in bad shape. I just could not do the work. Wayne is a pleasant and congenial individual, but he can not cut in a ceiling or wall to my satisfaction - not even close. He should have a putty knife and wet cloth with him all the time to correct any paint that might get applied where it shouldn't. That is something I always did as a painter. I would not recommend Wayne to paint anybody's home.
Most pros don't bother cleaning brushes and rollers if they are going to use them the next day on the same job. "Latex paint dries slowly in cold temperatures," says Maceyunas. For two-day jobs, he wraps the rollers and brushes in plastic grocery bags and sticks them in the refrigerator. "Just allow the roller to return to room temperature before reusing it," he says. Roller covers are almost impossible to clean thoroughly. Most pros buy new covers for each job.
I totally agree with this as well. I think every time I have read Angie's List reports, they are inaccurate and not researched enough. I had COMPLETE faith in Angie but lately I am hesitate on reports. I would check your local hardware store or even your neighbors to get a recommendation for painters. If you liked what you saw, you can be stress free with your results. I live in Texas and I have borrowed my hardware store opinion bc that seems to be the place most of the contractors or painters come to buy stuff for the jobs. If your neighbors painters, contractors, electricians and plumbers have shown good results, stress free you. I have been stress free with results, glad I asked for other opinions.Don't forget, the Hardware Store knows if that person is trustworthy and honest, their accounts would be shut down.
Before the pros paint walls, they fill holes and patch cracks with joint compound. But if you paint directly over it, the compound will suck the moisture out of the paint, giving it a flat, dull look (a problem called "flashing"). Those spots will look noticeably different than the rest of the wall. To avoid that, pros prime the walls before painting.
The Information in this post is based on our cost. ALLBRiGHT 1-800-PAINTING serves the Greater Los Angeles Area, and our cost tends to be pretty competitive with most professional painting contractors in this region. You can always find “cheap” painting cost, but typically those estimates will be missing key things such as proper licensing, insurance, worker’s compensation, or untrained painters.
When painting the trim, you don’t have to be neat. Just concentrate on getting a smooth finish on the wood. Don’t worry if the trim paint gets onto the walls. You’ll cover it later when painting the walls. Once the trim is completely painted and dry (at least 24 hours), tape it off (using an “easy release” painter’s tape), then paint the ceiling, then the walls.
Color is always the first consideration when painting a home. Most paint manufacturers offer samples to try that can allow you to make a more informed decision. Because light within a room may vary from wall to wall as well as from day to night, try painting a large piece of poster board in the color or colors you are considering. Move the board from wall to wall and look at it for a minimum of 24 hours at a time in each space to make sure you like the color before committing.
Painting is a skilled job with plenty of room for error, from knowing how to prepare the appropriate surface to understanding the best interior paint for the situation. When you book through Handy, we match your job’s requirements with experienced house painters who will leave you completely satisfied. They'll arrive with the right equipment in hand, ready to roll.
If you paint over dirty, oily surfaces, the paint will easily chip or peel off. So before painting, clean grimy areas with a deglosser or heavy-duty cleaner intended for prepaint cleaning. They work well to clean painted, varnished or enameled surfaces to improve the adhesion of the new paint. They’re ideal for cleaning greasy or oily areas like kitchen and bathroom walls and removing hand marks around light switches and doorknobs.
To get basic measurements, measure the length and width of each wall you want to paint in inches. Multiply the length and height together, and divide by 144. This will give you the square footage for each wall. A gallon of paint typically covers around 400 square feet. In some cases, you may need a primer 2 first, then a single coat of paint, meaning that you may need one gallon of primer and one gallon of paint to cover 400 square feet. However, if the wall requires multiple coats, this will increase the total amount of square footage required, and therefore the amount of paint.