Basic labor to paint home with favorable site conditions. Prep up to 3 hr per 100 SF - clean, scrape, sand and patch up to 4 defects per 100 SF. Caulk gaps and spot prime. Roll / brush 2 coats of paint over lightly textured ceiling/walls. Paint up to 2 doors and door trim per room. Includes planning, equipment and material acquisition, area preparation and protection, setup and cleanup. 129 square feet $93.64 $126.68
The Cutters. Someone with meticulous attention to detail and a steady hand should be assigned the job of "cutting in," or painting a straight edge where needed, such as along a wall where the ceiling does not get painted. Many products are available to assist, but none work as well as a person who's good at doing it freehand. Ensure this person is skilled (ask them to show you). A poor, jagged, wavy or splotched cutting-in job will jump out at you every time you walk by it. Why more than one cutter? This job is nerve-wracking and painful to hands and arms after a few days. You'll want to give this person a break after a few walls.
In general, glossier paints are more stain-resistant and scrubbable. But a higher sheen also highlights any imperfections in the wall or in the paint job. "Flat paints are fine for ceilings and formal rooms, but for most of my customers, I recommend an eggshell gloss. It's good for hallways, kids' rooms, even kitchens and baths," says Toto. It seems that latex paints have won over even the most finicky painters. "Though we still use oil-based paints for restor-ation work, latex paints are fine for interior walls and new trim," says Toto, "as long as you don't go cheap on the paint." All of our pros have their personal favorites, but they agree that good paint does not come cheap. "You'll spend $20 to $35 per gallon for a top-shelf paint," says Weeks. The pros also agreed that using two coats of paint will result in the best-looking job. Don't skimp on the coverage; if you're covering more than 400 square feet per gallon, you're spreading it too thin. Also, keep 1/4 to 1/2 gallon on hand for touch-ups.
Painting the doors and the door frames is not always part of the main paint job. There are two main reasons for that. Doors are painted in more durable semi-gloss or satin paint which last longer and is washable. The other reason is cost savings. Painting trim such as doors and door frames is time consuming and relatively more expensive than walls. There are three basic types of painted doors.
Second coats on similar colors are almost never recogicnized as being needed until the coat is applied and has dried. ONLY THEN WILL YOU SEE WHETHER IT NEEDS A SECOND COAT or not. Yes, painters can use a cheaper paint then what you paid for. That is solved by getting your own which, I would charge extra for because I will always have to go get more, or add second coat because home owner tried to skimp on paint, or they got the wrong color etc...
Your home is one of your biggest investments, and with most things in life, you get out what you put in. Get ready to transform the look, feel, and even the value of your home at a competitive price with painting services by New Life Painting. Our professional painters are ready to transform your interior living space – get started with your free estimate today.
We had a bad experience with an interior painter years ago, with the crux of the problem being him overcharging us at the end for "extra work" he didn't anticipate. One thing I'd strongly recommend is making sure it's in the contract that any additional work or growth work is estimated and communicated to the owner as soon as it is identified, otherwise the owner is not liable to pay it at the end.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges
You may think you're home safe with a low- or zero-VOC paint, but once it's tinted with the universal colorants used in most paint stores, it could be anything but. On average, these colorants add about 150 grams of VOCs to a gallon; darker shades have more. To get around this, either settle for colors that are factory-mixed or look for paints with no-VOC tinting systems, such as Mythic, Freshaire Choice, or Yolo Colorhouse.
Preparing and painting the interior walls of a room can usually be done in a few hours. However, drying time between coats can extend the job to a few days. If trim or ceilings are added to the job, you should account for a few hours for each coat. Projects that are more extensive or customized, involve different colors or types of paint or require extra prep work will take more time to complete.
Even an old lamp with a bare bulb held close to a wall will make minor cracks, bumps or nail pops jump out. Carmen Toto, owner of C. Toto & Sons in Madison, New Jersey, uses painter's putty or a lightweight spackle for minor cracks and dents; he uses plaster of Paris for dents deeper than 1/8 inch. Instead of the standard tape-and-spackle method for bridging over recurring stress cracks, Maceyunas uses a rubberized spray-on primer called Good-Bye Crack. Damaged wood requires a slightly different approach. "Don't use spackle on wood," says Toto, "because it just won't stick." For damaged trim, he uses painter's putty or a two-part wood filler, such as Minwax's High Performance Filler. Smooth any repairs, bumps, and nibs with a drywall pole sander. For smoother walls and better adhesion, some of our pros sand all previously painted walls regardless of the shape they're in.
My husband has been a professional painter over 30 years. He prides himself in his high level of work ethic and customer satisfaction. He stays up to date on techniques and finishes. He gives Very detail and accurate appraisals with contracts. At an alarming rate, as he starts to finish the last day or the day before, the client starts nit picking and being disrespectful towards his work when every day prior to that, they were very pleased, as he request ongoing satisfaction throughout the job. Then they don't to want pay remaining balance, bicker about final cost, or stop payment. He has a crew he has to pay whether the customer does or doesn't honor the contract as well as our own household expenses. Wasted time ,labor, money and effort lost. Now how do we fix this? Remind yourself and clients that a contract is based on honor.
Most pros don't bother cleaning brushes and rollers if they are going to use them the next day on the same job. "Latex paint dries slowly in cold temperatures," says Maceyunas. For two-day jobs, he wraps the rollers and brushes in plastic grocery bags and sticks them in the refrigerator. "Just allow the roller to return to room temperature before reusing it," he says. Roller covers are almost impossible to clean thoroughly. Most pros buy new covers for each job.