The companies with the best paint products are Benjamin Moore, Dunn Edwards, Sherwin Williams, and Vista Paint. As a painter I don't recommend Berh from Home Depot as much because it's quality is just marketing. Flat paint has no sheen and it shows its true color, but is not easy to wash or clean. Satin, eggshell have low sheen and is washable. Semigloss ang glossy has a high sheen and these paints are recommended for bathrooms and kitchen or where there's high humidity and steam.
You may think you're home safe with a low- or zero-VOC paint, but once it's tinted with the universal colorants used in most paint stores, it could be anything but. On average, these colorants add about 150 grams of VOCs to a gallon; darker shades have more. To get around this, either settle for colors that are factory-mixed or look for paints with no-VOC tinting systems, such as Mythic, Freshaire Choice, or Yolo Colorhouse.
The Cutters. Someone with meticulous attention to detail and a steady hand should be assigned the job of "cutting in," or painting a straight edge where needed, such as along a wall where the ceiling does not get painted. Many products are available to assist, but none work as well as a person who's good at doing it freehand. Ensure this person is skilled (ask them to show you). A poor, jagged, wavy or splotched cutting-in job will jump out at you every time you walk by it. Why more than one cutter? This job is nerve-wracking and painful to hands and arms after a few days. You'll want to give this person a break after a few walls.
The problem with painting along the edge of textured ceilings is that it's almost impossible to get a straight line along the top of the wall without getting paint on the ceiling bumps. Pros have a simple solution. They run a screwdriver along the perimeter of the ceiling to scrape off the texture. "This lets you cut in without getting paint on the ceiling texture," one of our pros says. "The screwdriver creates a tiny ridge in the ceiling, so the tips of your paint bristles naturally go into it. And you'll never even notice the missing texture."

Just like with roller paint application, painters are not limited to using just one stroke when cutting in. It is important, however, to work towards the edge of the corners applying even pressure. If time permits, painters should allow their cut in work to dry completely before applying paint with rollers, keeping in mind that light touchups on corners and edges will always be required at the end.


FIRST: Unless you can stay in business painting 1 bedroom at a time for $500-$1000, which you can't, then you will be taking on several thousand dollar contracts that require thousands in Labor and Materials to fulfill the order. Multiply that by 3-4 jobs at one time or in our case 15-20 jobs at a time, YOU NEED TO TAKE DEPOSITS!!! It is horrible business not to take deposits. There are many jobs where its not possible to get a deposit and that is built into or pricing accordingly. If we are not getting a deposit, there is a finance charge built in, contractors are not banks. If you don't have a good feeling about a deposit, your hiring the WRONG CONTRACTOR. Hire people you know or well established businesses.
If you are going to hire a contractor (professional painter) give a room by room punch list of the fixing of holes small or big, have it identified for the painter to tell you if you need a drywall finisher or if he does this type of work good. Wall repairs can be 3-5 steps to do repairs ( one per day for good drying of patching material and a good sanding) this is what gives you a good paint job only using high quality paint.
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.
Keep an eye on the new cans as they're being brought in. Make sure they look new and don't have paint in the rim of the can. If it's a five-gallon bucket, check to see whether the lid is still sealed on with the plastic strip. The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water.

The cost to paint a room will vary based on the size of the room, the type of paint you select, any ceiling or trim work needed, and any repairs needed. If no repairs or other additional work is needed, painting a room with contractor-grade paint could range from $1 to $2 per square foot, including materials. Selecting a luxury paint (some cost more than $100 per gallon) will certainly increase your house painting costs. Here are some additional examples of average house painting costs, per room:


We hired Warline to paint our house inside and out as part of our extensive heritage renovation. Warren and his team of experts took the time to find out what we really needed, not just what we wanted. They then set up a plan to get the interior of our house painted amidst complete renovation chaos. Once the outside was ready, they then came back and finished the job by beautifully painting the exterior. They even came on the weekend as it was going to be the only sunny day. It’s the details that make the difference in a good company.

Only a dummy gets involved with so-called "contractors." Hire a qualified actual worker yourself. Check out their resume/background, etc. RULE #1..NO ADVANCE DEPOSITS! Pay daily or weekly or upon satisfied completion according your standard, not workers. Contractors are merely employment agents. If that's the way you get work done, then go ahead and waste your money and wind up with the myriad of problems enumerated upon in the news clip above. RULE#2.. NO SMOKERS. They are lighting up on your money. RULE#3: No cell phones while working. Talk on their own time after work
A good paintbrush is key to a professional-looking finish. "A quality brush costs $15 to $25, but you'll discover that pros aren't as talented as you thought," says Doherty. "The equipment has a lot to do with their success." Most of our pros prefer natural-bristle brushes for oil-based paints, but they recommend synthetics for all-around use. When choosing a brush, pay attention to the bristles. Synthetic brushes are made of nylon or polyester, or a combination of the two. Poly bristles are stiffer, which makes them good for exterior or textured work, but for fine interior work, Doherty uses softer nylon brushes. Look also for tapered bristles, which can help you work to an edge, and flagged tips, which help spread the finish smoothly and evenly. Brushes are available in 1- to 4-inch widths. Most painters keep an arsenal on hand to match the job. "Use common sense," says Maceyunas. "A smaller brush gives you more control, but no one wants to paint a door with a 1-inch-wide brush." Doherty recommends starting with a 2- or 2-1/2-inch sash brush. The angled brush makes it easier to cut to a line and puts more bristles on the work than a square-tipped brush.

House Interior Painting

×