Recently I had my kitchen cabinets painted with Warline. The workmanship is incredible. They were always on time, very considerate and managed all the details of my project with great care. During the entire process Heidi made me feel as though I were her only client and always made me feel at ease. I can't recommend Warline enough, and will be calling them every time I need painting.  
Hi, I’m Luis. I have many yrs of experience and expertise doing some of the following jobs ; Handyman, Car Mechanic, Detailing, Pressure Washing, Deliveries, Towing and many others. I’m very honest and detail on what I do and you better believe that I personally take good pride on every single job I do. Thanks for looking at my Bio. Looking forward to help you with your needs.

Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas.
Sand the trim with a fine-grit sanding sponge. Sponges get into crevices where sandpaper can’t go and let you apply even pressure. Then apply the first coat of paint, let it dry at least 24 hours, lightly sand it again for a completely smooth surface, and apply the second coat. After each sanding, vacuum the trim, then wipe it down with a tack cloth to remove the dust.

Spills and spatters happen, regardless of how careful you are. It’s a lot easier to pre- pare for them than to wipe them out of your carpeting or off your wood floor later. All it takes is canvas drop cloths in your work area (a 4-ft. x 15-ft. cloth costs $15). The thick canvas stays in place, so you don’t need to tape it, and you can use it to cover any surface. Plastic drop cloths are slippery to walk on or set a ladder on and don’t stay in place. Even worse, paint spills on plastic stay wet, and they can end up on your shoes and get tracked through the house. Canvas is slippery on hard floors, so rosin paper ($10 for 400 sq. ft. at home centers) is better over vinyl, tile and hard- wood. Tape the sheets together and to the floor to provide a nonslip surface.
The pros were split on this tip. "Masking tape is problematic," says Mark Dixon, a painter in Missoula, Montana, and author of "House Painting Inside and Out" (Taunton Press, 1997). "Paint can bleed behind the tape, or remove the paint it's stuck to." Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) On the other hand, "If you can't cut in, you can't beat tape," says Span. The pros we spoke with all recommend painter's (blue) tape because it's easier to remove than masking tape. To prevent bleeding, Span uses a putty knife to bed the tape. After letting the paint dry, he scores the edge of the tape line with a utility knife to avoid tearing the paint.
To get basic measurements, measure the length and width of each wall you want to paint in inches. Multiply the length and height together, and divide by 144. This will give you the square footage for each wall. A gallon of paint typically covers around 400 square feet. In some cases, you may need a primer 2 first, then a single coat of paint, meaning that you may need one gallon of primer and one gallon of paint to cover 400 square feet. However, if the wall requires multiple coats, this will increase the total amount of square footage required, and therefore the amount of paint.

House Interior Painting Design Co


"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.
Keep in mind that color can impact the way a room appears in many ways. Light colors may help brighten a darker space. Cool colors will recede visually from the eye, and make a small space appear bigger. Warm colors contract visually, which can make larger spaces appear smaller or more cozy. Combining cool and warm tones in one room - like with accent walls - can visually change the shape of a room, making rectangles look more like squares.
I'm hiring an interior painter and that is why I was reading this comment list. I'm concerned about your comment about Angie's List. Some of us don't have personal recommendations for tradespersons, and rely on sites like this. Are you saying that Angie's List's reviews are not complete or that they do not print some of the negative reviews? It's hard to know what to do - I have not been able to find a person who just had their paint done so I can ask him/her about the quality of the painter.
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.
Most pros don't bother cleaning brushes and rollers if they are going to use them the next day on the same job. "Latex paint dries slowly in cold temperatures," says Maceyunas. For two-day jobs, he wraps the rollers and brushes in plastic grocery bags and sticks them in the refrigerator. "Just allow the roller to return to room temperature before reusing it," he says. Roller covers are almost impossible to clean thoroughly. Most pros buy new covers for each job.
Keep in mind that color can impact the way a room appears in many ways. Light colors may help brighten a darker space. Cool colors will recede visually from the eye, and make a small space appear bigger. Warm colors contract visually, which can make larger spaces appear smaller or more cozy. Combining cool and warm tones in one room - like with accent walls - can visually change the shape of a room, making rectangles look more like squares.
Sandy and I would like to thank you very much for the wonderful job you did painting our house. From the initial quote from Warren to the final brush stroke from your painting crew, the entire experience was completely stress free and enjoyable. Heidi, your advice on paint colors was very helpful. Our house has been transformed and we couldn't be happier. Thanks again for making our dream of a showcase home a reality.
Your small home is the perfect spot for a sunny little kitchen. A warm yellow like Benjamin Moore's Hawthorne Yellow would look great with white cabinets, subway tile walls, and a weathered gray tile floor. The secret to choosing the right yellow paint color for your small kitchen is to sample light yellow colors first, then increase the intensity if you don't get the look you want right away.

Pros prefer 5-gallon buckets with a roller grid to roller pans. They hold more paint than pans and, says Doherty, "It's tougher to tip over a bucket." A bucket also lets you box, or mix, two or three cans of paint to avoid color discrepancies. To use a bucket and grid, dip the roller a quarter of the way into the paint and run it over the ramp to work the paint into the nap.
A painter's rod, or pole, can help you paint ceilings more quickly — no climbing up and down ladders required. And there's no need to stand directly underneath the area you are painting, so you won't catch every wayward splatter. A pole is also great for walls and floors. The pros were split over whether the 4- or 8-foot pole is best for everyday use, but they all agreed that a telescoping rod is the best bet.

So, you’ve chosen your paint colors (hues & all) with the proper finish for each room of the house. But how do you ensure that moving through each, freshly painted, room won’t make it seem like you changed your mind a few too many times? The answer is easily answered with one word…. Well, two words… baseboards & molding. Though the dominant colors & their respective finishes may vary in each room, you should choose one color & finish for any accent pieces.

Home Interior Painters Design Co

×