Pros prefer 5-gallon buckets with a roller grid to roller pans. They hold more paint than pans and, says Doherty, "It's tougher to tip over a bucket." A bucket also lets you box, or mix, two or three cans of paint to avoid color discrepancies. To use a bucket and grid, dip the roller a quarter of the way into the paint and run it over the ramp to work the paint into the nap.
Most painters have no problem painting doors in place, but they recommend you lay the door on sawhorses and work horizontally. If you have a paneled door, start with the panels and work from the outside edges in toward the center. "Watch the corners — paint loves to puddle," warns Dixon. While the paint is still wet, lightly "tip off" the panel with an almost dry brush. (Tipping off is pulling the brush over the surface to level out the finish.) When painting the stiles (vertical) and rails (horizontal) just follow the grain of the wood. When the grain changes abruptly, for instance, where the rail meets the stile, don't stop your brush stroke — you'll only leave a lump of paint. Apply paint across the joint with a full stroke, and then tip off the overlapping section by pulling the brush in the direction of the grain. "Make sure the door is dry before painting the opposite side or rehanging it," says Maceyunas.
For interior paint I prefer the semi-gloss, provides a very subtle sheen and is super easy to clean -no flaking, chipping, etc. I've painted a lot, and found that Sherwin Williams Ovation paint has been the easiest to use, and provides the best coverage. I even painted my ceilings with it and WOW! I was done it no time at all, with perfect coverage.
Painting interior walls is a task better accomplished with foam rollers, because they are easy to use and can evenly cover large surface areas quickly. Foam rollers and brushes should never be overloaded with paint, as it can create drips, uneven coverage and can take longer to dry. It’s easy to get frustrated when the paint is fresh and does not look like a photo from the paint catalog, but remember: that’s something that usually happens after the second coat dries.

I found Warline Paint to be honest & very professtional from start to finish. The crew arrived on time, was friendly and cleaned up afterwards. They did an excellent job of prepping and paintiing. The walls look so smooth now. I am very pleased with the results. If you want top quality work done I would highly recommend them. Thank you to Warren and his hard working crew.
Before the pros paint walls, they fill holes and patch cracks with joint compound. But if you paint directly over it, the compound will suck the moisture out of the paint, giving it a flat, dull look (a problem called "flashing"). Those spots will look noticeably different than the rest of the wall. To avoid that, pros prime the walls before painting.
Paint companies continue to update their formulas, making them "green" by stripping out chemicals that are unhealthy for our families and the environment, boosting colorants for more vivid hues, and adding high-tech ingredients to provide greater durability. The problem is, paint aisles are now crowded with so many choices that it's hard to decide what to buy. And unless you know what you need and where to find it, each can looks pretty much the same.
@Neil What is the use of repeating lessons when there is so much more to be learned? Technology has moved on from the adz. Plumbers use PEC, insulation is sprayed, glue-lams allow for open floor plans and furnaces are no longer stoked with coal. As for the new people, if these trades cannot attract fresh blood we will all be unable to get homes built and repairs made. I don't yearn for my first home with the leaky concrete block foundation, failing well pump and an oil furnace held up by the plenum. I'll take heat pumps, solar panels and PVC waste pipes any day.You can get all the sill plate repairs and flitch beams demos you need on YouTube.
Paint companies continue to update their formulas, making them "green" by stripping out chemicals that are unhealthy for our families and the environment, boosting colorants for more vivid hues, and adding high-tech ingredients to provide greater durability. The problem is, paint aisles are now crowded with so many choices that it's hard to decide what to buy. And unless you know what you need and where to find it, each can looks pretty much the same.
The Coordinator. This person will care for the needs of the rest of the workforce, fetch drinks, make sandwiches, make runs to the store for last-minute needs, cook (or arrange) lunch and dinner, make phone calls, get directions, wash brushes, etc. Don't underestimate the need for this key person! When not gainfully employed, he or she can do some rolling.
You may not have heard this since your days in elementary school, but bust out the color wheels here folks (just in case you misplaced yours, we provided one for you). It’s one of the easiest ways to pick out what colors go with each other. Complementary hues (ones that go well with one another) are opposite each other on the color wheel. This isn’t by accident. It’s one of nature’s subtle ways of telling us it’s still in charge.

Paint preparation is the foundation for the entire job — if done correctly your paint will perform to its fullest potential. If done incorrectly, the best paint will crack, peel, or chip easily. Make any necessary repairs before you start your painting project. Dirty walls should be cleaned, especially near the stove and sink. Greasy deposits and soap scum can interfere with paint's adhesion.


Cleaning oil-based paints can be a challenge. Sometimes it’s best to let your tools dry and throw them away. However, if you plan on saving your tools you’ll need mineral spirits, paint thinner or lacquer thinner, a cleaning comb or brush and two metal containers or glass jars with lids. One container will be for clean solvent and the other for dirty solvent.
Just as with exterior painting, picking the right color scheme for interior spaces requires a certain amount of imagination and creativity. Simply thinking about what color would look best on a wall isn’t enough to ensure a positive paint job. Virtually any color will look good on a surface as long as it is applied correctly, but choosing the right color involves looking at an interior space with a very critical eye.

Paint companies continue to update their formulas, making them "green" by stripping out chemicals that are unhealthy for our families and the environment, boosting colorants for more vivid hues, and adding high-tech ingredients to provide greater durability. The problem is, paint aisles are now crowded with so many choices that it's hard to decide what to buy. And unless you know what you need and where to find it, each can looks pretty much the same.
Dave, you said it best! Every pro painting contractor truly worth their salt would and should cut and paste exactly what you say here about where customary and legitimate practices and expectations should be in regards to what customers should expect from contractors and how contractors should professionally deal with their customers. By the way, Dave, if you work in the Atlanta area, I would like to hire you! Thank you for your valuable advice!
I disagree with your criteria to hire a painter. A prompt returned call is nice but does not indicate the quality or fairness of the painter. As far as a written estimate, that should be more of a qualifier for the bid versus an evaluation criterion. I'm not sure one would have favorable results by hiring a painter on this basis. As far as the bidding process, change orders should ONLY be used if the customer requests additional scope (PMP 101). Angie's list should consider asking reviewers if/how much they were told to pay compared with the estimate. Unfortunately, there are a lot of contractors that are unethical and need to be accountable.
We contracted with Warline to repaint the exterior of our townhouse complex. This was a complex job with multiple elevations and a demanding client (42 owners to please). Our conclusion was that the job could not have gone better. Warren Nyline and his employees were extremely attentive to detail and ensured that all surfaces were thoroughly cleaned, repaired where necessary and beautifully painted. There were very few deficiencies and those identified were addressed immediately.
"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.

To get basic measurements, measure the length and width of each wall you want to paint in inches. Multiply the length and height together, and divide by 144. This will give you the square footage for each wall. A gallon of paint typically covers around 400 square feet. In some cases, you may need a primer 2 first, then a single coat of paint, meaning that you may need one gallon of primer and one gallon of paint to cover 400 square feet. However, if the wall requires multiple coats, this will increase the total amount of square footage required, and therefore the amount of paint.

House Interior Painting Design Co

×