The best time to tackle windows is in the beginning of the day, when you're fresh," says Doherty. "But it still takes me an hour to do a standard window." For double-hungs, begin by raising the inner sash and lowering the outer sash until their positions are almost reversed. Paint the lower half of the outer sash first, then the entire inner sash. Once the lower sash is dry, return both to their normal position, but leave them slightly open. Finish painting the outer sash. "Windows take too long to tape," says Doherty. When painting, overlap the glass by 1/16 inch to seal the wood.
Yes the pricing does change, and quite significantly. I have worked inside the paint industry on counter sales outside sales and application for over 10 years. One thing many people do not understand is, the resins in the paint are more expensive to produce the higher the sheen goes. Therefore the company is at of higher cost making the paint, which in terms they charge more for the paint. I have seen a 15$ variance between flat-semi-gloss it is not uncommon and is not unrealistic to pay more for a higher sheen. Another thing to add is when doing samples on your wall prior to a painter coming is a good idea, however do not do them in huge squares with heavy coats, remember you are just wanting an idea. A lot of times the issue comes up of the paint not covering the sample coats, in fact it is covering quite well, however the paint sample applied is often times much darker than the wall color, creating a contrasting difference from the lighter surrounding wall and the sample placed on the wall. I recommend getting a piece of sheet rock and using it for the samples so you can move around with it etc.
"Modern paints dry too quickly, and are difficult to brush out," says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. "Adding a few ounces per gallon slows drying time and makes the paint more workable," he says. Another problem is bridging. "Latex paints form a skin," says Dixon. "Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line." Lastly, taping takes time. "Learning how to cut in with a brush takes practice, but if you can do it, you'll leave most tapers in the dust," Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. "These paints will prevent mildew from forming, but they won't kill mildew that's already there," Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser's Bulls Eye 1-2-3 or Kilz's Total One.

I am a painting contractor and have been since 2001. Make sure the estimate provides in writing: What is EXCLUDED as well as INCLUDED. It should state the manufacturer and type of paint going to be used. Estimate says ALL LABOR AND MATERIALS. My estimates to my customers say "guaranteed coverage" eliminates the conversations of 1 coat vs 2 coat. I have my customers submit colors 5 days prior to start date. Customers need to inform me if they are going to use pure white, dark reds, oranges, and bright yellows they need to inform me in that 5 day window, so I can adjust my pricing for 3 coats. Although this more uncommon now than years past because a lot of paint manufacturers have primer with paint products. Let the contractor know if your doing accent walls. This takes longer to cut in straight lines and it requires the contractor to purchase more paint. If you add anything on the scope of work have the painter write out the description and cost prior to them doing the work. Have the estimate say how many days it will take to perform the work. Ask how many workers will be doing the job. Make sure to enforce that number of workers their everyday until the job is complete. Do not give final payment until you do a final walk through. Walk the job when its almost complete and point out areas that you want fixed prior to the contractors final walk through. Its best to do while the workers are still in that particular area as they will have tarps down and areas covered and it will be easier for them to take care of. Purchase a roll of blue tape and stick it to areas that you want fixed. This is called a punch list.


Gray is a timeless color, but it could also be considered drab if not accessorized with bold colors. Anyone who has grown tired of looking at white paint on walls for years should consider gray tones. Gray paint is cooler than its white counterpart and more versatile, as it manages to blend well with most decorations. It is an ideal color for all interior spaces and provides the perfect backdrop for color bursts.
Shopping for the right paint should go beyond collecting paint swatches or choosing a shade from the catalogue. Purchasing inexpensive paint samples and small brushes to bring home for testing is the best, because it's the only way to really ascertain whether a color suits the décor. The goal is to paint a small section of the wall — a square with an area of just a few inches is sufficient. Allowing the small painted patch to dry and observing how it looks under the lighting conditions at different times of the day should clear up any painter’s color dilemma.
To get basic measurements, measure the length and width of each wall you want to paint in inches. Multiply the length and height together, and divide by 144. This will give you the square footage for each wall. A gallon of paint typically covers around 400 square feet. In some cases, you may need a primer 2 first, then a single coat of paint, meaning that you may need one gallon of primer and one gallon of paint to cover 400 square feet. However, if the wall requires multiple coats, this will increase the total amount of square footage required, and therefore the amount of paint.
Friends of ours had their house painted by Warline Painting and were really pleased with the job. When Warren came to our house he had many good ideas about what we should do. Heidi then showed up with help picking our colours. The job was done shortly thereafter and looked great. We were away for a few days and before we had a chance to contact Warren he left a message that he had checked the doors and they needed a little touch up. He had noticed little inperfections and came to fix the problem before we even knew we had them. It is great to finally find a trade company who treats your house as though it's their home.
To pick the right color for your space, grab lots of paint chips, place them on the wall near the trim, and look at during different times of the day to see how light affect the color. When you’re ready to start testing shades, paint sample colors onto sheets of heavy paper instead of the wall so you can move them around and not make a mess of your walls. 

I am a painting contractor and have been since 2001. Make sure the estimate provides in writing: What is EXCLUDED as well as INCLUDED. It should state the manufacturer and type of paint going to be used. Estimate says ALL LABOR AND MATERIALS. My estimates to my customers say "guaranteed coverage" eliminates the conversations of 1 coat vs 2 coat. I have my customers submit colors 5 days prior to start date. Customers need to inform me if they are going to use pure white, dark reds, oranges, and bright yellows they need to inform me in that 5 day window, so I can adjust my pricing for 3 coats. Although this more uncommon now than years past because a lot of paint manufacturers have primer with paint products. Let the contractor know if your doing accent walls. This takes longer to cut in straight lines and it requires the contractor to purchase more paint. If you add anything on the scope of work have the painter write out the description and cost prior to them doing the work. Have the estimate say how many days it will take to perform the work. Ask how many workers will be doing the job. Make sure to enforce that number of workers their everyday until the job is complete. Do not give final payment until you do a final walk through. Walk the job when its almost complete and point out areas that you want fixed prior to the contractors final walk through. Its best to do while the workers are still in that particular area as they will have tarps down and areas covered and it will be easier for them to take care of. Purchase a roll of blue tape and stick it to areas that you want fixed. This is called a punch list.
The actual painting and finishing work went very well, this company hires people who are looking to work for a solid company and it shows. Everyone is a professional and the completed job looks great! Needless to say, we highly recommend Warline for painting and color consulting/decorating services. Thank you to Warren, Heidi and the whole team, this may have been the best choice we made!
As a former professional painter, something that drives me crazy is when I see painters cut in around wall plates. First of all, the amount of time that it takes to cut in is usually much longer than the amount of time that it takes to simply remove the wall plate. Secondly it does not look nearly as clean as it does when the wall plate is removed and thirdly it can invariably leave paint on the wall plate itself which also looks sloppy. Make sure the painter takes them off and then reinstalls them. It's less time.
An easy way to calculate the square footage of a room, is to measure and add the total length of the all the walls, then multiplying that total by the height of the room. If there are big areas within that space that are not getting painted, it’s a good idea to deduct their square footage from the total. Examples are: a large window wall, double doors, or a wallpapered wall. If two coats are required, the measured square footage is doubled. In a 10 by 14 room the walls have a linear length of 48 feet. Multiplying 48 times 8 (the height of the walls) will give us 384 square feet of paintable wall.
We don’t believe in handing our customer a roll of tape and asking them to check for deficiencies. That’s our job and we take it seriously. Our quality control is ongoing and done through every step of the project. Our interior painters are constantly checking their own work and our team leaders conduct a full inspection of the job when it’s completed. Our layers of quality control and inspections mean that when we are done, and you do a final walk through, the only thing you should be seeing is a beautiful paint job.

Generally, it will take a minimum of two gallons of paint to cover a room. At the highest end, paint will cost anywhere between $30 and $60 per gallon and come in three different finishes: flat, semi-gloss or high-gloss. Flat finishes are the least shiny and are best suited for areas requiring frequent cleaning. Semi-gloss finishes are a bit shiny but can also be easily cleaned. A high-gloss finish is stain-resistant and easy to clean. Traditionally, living rooms should be painted with a flat finish to allow the paint to stand out. Glossy finishes should be reserved for hallways, and a semi-gloss is best suited for trim. Invest in pre-primed paint whenever possible. This cuts down on time by combining the layering process. Almost any paint job will require a primer, which will cost anywhere from $7 to $15 per can. Primer helps the paint to stand out against the underlayer of paint it's covering, especially if the new paint is lighter than the old coat. You will need at least two cans of primer, if not more, to cover one wall. Here are some paint brands and their average price per gallon:
×