So, you’ve chosen your paint colors (hues & all) with the proper finish for each room of the house. But how do you ensure that moving through each, freshly painted, room won’t make it seem like you changed your mind a few too many times? The answer is easily answered with one word…. Well, two words… baseboards & molding. Though the dominant colors & their respective finishes may vary in each room, you should choose one color & finish for any accent pieces.
When hiring a contractor it is always best to hire one who is personally referred to you by someone you trust. Hiring through ads or phone book is hit and miss. Check with your local paints stores, they know the good guys from the bottom feeders. Go to the stores that sell the high quality paints like Benjamin Moore(nonpareil), Pittsburg, Sherwin Williams or Glidden. Don't go the the big box stores for referrals, the people there don't know squat!
We don’t believe in handing our customer a roll of tape and asking them to check for deficiencies. That’s our job and we take it seriously. Our quality control is ongoing and done through every step of the project. Our interior painters are constantly checking their own work and our team leaders conduct a full inspection of the job when it’s completed. Our layers of quality control and inspections mean that when we are done, and you do a final walk through, the only thing you should be seeing is a beautiful paint job.
A can of paint is generally labeled "low-VOC" if it has less than 100 grams of VOCs per liter for flat sheens and 150 grams for nonflat. Cans that meet standards set by Green Seal, an independent tester and certifier of paints, have even less—no more than 50 grams per liter for flat finishes and 100 grams for nonflat. A "zero-VOC" paint can't have more than 5 grams per liter, according to Environmental Protection Agency standards.
to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.

Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.


I would not recommend this company for the following reasons:1. Original appointment was very specific to them on what was needed and to take photos for 3 apartment unit plumbing fixture repairs. One unit had a bathroom tub/shower backup.2. No photos taken, 3 trips later and only 1 unit completed to satisfaction. (Backup) 3. Other faucets unable to find on line with their suppliers and repair 4. Had to find another plumbing company to complete the jobs. 5. Invoicing had to be redone as not in detail of job address for tax purposes 6. Bad communication throughout the project process with their internal customer service. Their technician and project manager ordering parts. 7. For the back up. Did not bring out correct snake on both trips and had to replace lines as too small to break through backup. Costing over $800 for 3 trips just to complete that situation out. 8. Ordered the wrong parts when 2nd trip out since no photos taken to confirm what was needed. Very dissatisfied and will never ask them to work in any of our rental properties again. 

Home Interior Painter Design

×