The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water. (You never use a sprayer and need to thin paint.?) If i was still in the industry I'd take the time to make a better article than this. Take this for a grain of slat. Use a reputable painter or someone you know you can trust or has been referred to you by someone you trust. I wouldn't hire anyone I had to watch like a hawk to make sure they're not screwing me.
As a painting contractor I find that most contractors charge between $20 an hour and $45 an hour plus paint and materials pending overhead here in Pennsylvania i figure $30 an hour is a safe bet. figure a good painter should be able to prep a 12 x 12 to a 12 x 15 room, caulk, apply 1 or 2 coats to the ceiling 2 coats on the walls and 1 coat on all baseboards, trim, doors and crown moulding in an 8 to 9 hour day. This is with minimal or minor spackling repairs like nail holes and nail pops, not cracks and peeling tape. Thats extra paint is usually  $30 to $70 a gallon pending quality. A room this size will need 1 gallon for the ceiling 2 for the walls and maybe 1 gallon for the trim, doors ext... the square foot price is $1.50 - $3.00 as far as asking for money up front I never ask. If the home owner buys the paint there is no need for money and if your buying the paint and your an established contractor you have an account with your supplier's.  any ways that's my input and guidelines 
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges

Dave, you said it best! Every pro painting contractor truly worth their salt would and should cut and paste exactly what you say here about where customary and legitimate practices and expectations should be in regards to what customers should expect from contractors and how contractors should professionally deal with their customers. By the way, Dave, if you work in the Atlanta area, I would like to hire you! Thank you for your valuable advice!
I am a painting contractor and have been since 2001. Make sure the estimate provides in writing: What is EXCLUDED as well as INCLUDED. It should state the manufacturer and type of paint going to be used. Estimate says ALL LABOR AND MATERIALS. My estimates to my customers say "guaranteed coverage" eliminates the conversations of 1 coat vs 2 coat. I have my customers submit colors 5 days prior to start date. Customers need to inform me if they are going to use pure white, dark reds, oranges, and bright yellows they need to inform me in that 5 day window, so I can adjust my pricing for 3 coats. Although this more uncommon now than years past because a lot of paint manufacturers have primer with paint products. Let the contractor know if your doing accent walls. This takes longer to cut in straight lines and it requires the contractor to purchase more paint. If you add anything on the scope of work have the painter write out the description and cost prior to them doing the work. Have the estimate say how many days it will take to perform the work. Ask how many workers will be doing the job. Make sure to enforce that number of workers their everyday until the job is complete. Do not give final payment until you do a final walk through. Walk the job when its almost complete and point out areas that you want fixed prior to the contractors final walk through. Its best to do while the workers are still in that particular area as they will have tarps down and areas covered and it will be easier for them to take care of. Purchase a roll of blue tape and stick it to areas that you want fixed. This is called a punch list.
The perfect roller would hold a roomful of paint, leave the right amount of texture, wouldn't spray or fuzz, and would be easy to clean. Until somebody invents the ideal one, follow these tips to choose the right roller. "The longer the nap, the more paint the roller will hold, but it will also create more texture." says Dixon. "A 1/2-inch nap lamb's-wool roller holds plenty of paint without too much texture," says Dixon. "Less expensive rollers can work," says Span. "Just wash them first in dishwashing liquid to remove any stray fibers." Most of the pros we spoke with prefer 9-inch rollers over 18-inch models -- they are lighter, cheaper, and easier to use. Despite these shortcomings, Maceyunas swears by the wider roller. "The roller can do a whole wall in a few up and down strokes instead of in several dozen W and M strokes," he says.

Watering down the paint 50%? It will not cover. I am a contract painter and found that most people that I make a contract with immediately try to change the deal and get more than they are paying for. Sometimes, I let them cheat me as they may have other work that I wish to do but other times I put my foot down. I try to get the client to look at what I have done each and everyday if I am going from room to room. I cannot do this If I spray the entire project at once. Even when I have them inspect my work, they often just do not tell the truth and wish to scam me the contractor for more and more while paying the same as the original contract. Most people have not a clue how much work is involved in painting a house and just assume that the painter rolls out the work with no prep, sealing off the place to protect things that are not painted. All of my contracts state that if anything is in the way like babies, dogs, cars, plants and furniture that I cannot proceed and that it is their responsibility to move this stuff. I always seem to be turned into a furniture mover and never get paid to wrench my back. Fact is most people try to rob the contractor and this article tries to make it seem that the contractor is robbing the homeowners. My sister is a prime example of this as she always goes for the lowest bid yet expects a world class job. This means if you pay $500 for a two day paint job do not expect the contractor to live at your home for two weeks and make only $500.
Priming walls and ceilings is mandatory whenever you're painting new drywall or painting over a dark color. But it's smart to prime any time you paint. Primer serves three main functions. First, it blocks stains from bleeding through. Second, it allows one-coat coverage for the paint. Third, and most important, it improves paint adhesion, which greatly reduces blisters and peeling.
I had originally budgeted a lower amount for this project....painting had always been a DIY project in this home, so I didn't have a clue.    Now that I'm older and less nimble, I decided to hire it out.    Waldner's Handyman Services was very professional and worked with me to understand how costs were factored into my painting project.  I am very satisfied with the finished result and will use them again for future jobs. 
The problem with painting along the edge of textured ceilings is that it's almost impossible to get a straight line along the top of the wall without getting paint on the ceiling bumps. Pros have a simple solution. They run a screwdriver along the perimeter of the ceiling to scrape off the texture. "This lets you cut in without getting paint on the ceiling texture," one of our pros says. "The screwdriver creates a tiny ridge in the ceiling, so the tips of your paint bristles naturally go into it. And you'll never even notice the missing texture."
Generally, it will take a minimum of two gallons of paint to cover a room. At the highest end, paint will cost anywhere between $30 and $60 per gallon and come in three different finishes: flat, semi-gloss or high-gloss. Flat finishes are the least shiny and are best suited for areas requiring frequent cleaning. Semi-gloss finishes are a bit shiny but can also be easily cleaned. A high-gloss finish is stain-resistant and easy to clean. Traditionally, living rooms should be painted with a flat finish to allow the paint to stand out. Glossy finishes should be reserved for hallways, and a semi-gloss is best suited for trim. Invest in pre-primed paint whenever possible. This cuts down on time by combining the layering process. Almost any paint job will require a primer, which will cost anywhere from $7 to $15 per can. Primer helps the paint to stand out against the underlayer of paint it's covering, especially if the new paint is lighter than the old coat. You will need at least two cans of primer, if not more, to cover one wall. Here are some paint brands and their average price per gallon:

Prep the house. Wash the walls, remove wallpaper, patch, spackle, seal stains, dry and sand before you attempt to paint. Now is also the time to apply painters tape for trimming, lay drop cloths, etc. Remove all outlet and light switch face plates, collecting screws in a zip-top bag (good opportunity to wash the face plates all at once as well). You can also buy your paint at this time. Don't wait until the last minute. It can take hours to mix many gallons of all your colors. Remember that traffic triples at your home-supply and hardware stores on weekends. Buy on a weekday if possible.
It’s important to note that complimentary hues work best with each other when they are of the same value. Referencing the provided color wheel, you’ll notice that each pie wedge is segmented into rings of decreasing size. And the value of each hue changes as the rings get smaller. So, if you’ve decided your kitchen needs to be a pure red (the outermost red), then it’s complimentary color is going to be a pure green (opposite & outermost on the ring).
Here is where this affects you as a consumer. You select a painter with a contract that says 2 coats, $500 down. You give the company the deposit and pick your colors a couple of days before the project starts. The painter goes to the store with your colors and figures out they are deep base. He (or she) not only needs to charge you more for the paint, but he also needs to charge you for a dark gray primer coat. Ninety nine percent of the time that primer coat is going to be really, really expensive since you already gave a deposit.
Sanding not only feathers out chipped paint but also provides "tooth" for the next coat of paint. For glossy trim, use a sanding sponge rather than sandpaper. Sponges mold to the shape of the trim and last longer than paper. When applying latex over alkyd paint or when he is not sure of the original finish, Brian Doherty, a painter in Richmond, Virginia, follows the hand-sanding with liquid sandpaper to make sure the surface is completely deglossed to prevent incompatibility problems. "I've seen homes where latex was used on oil-painted trim, and the paint started to peel in less than a year," says Doherty.
Recently I had my kitchen cabinets painted with Warline. The workmanship is incredible. They were always on time, very considerate and managed all the details of my project with great care. During the entire process Heidi made me feel as though I were her only client and always made me feel at ease. I can't recommend Warline enough, and will be calling them every time I need painting.  
The best home office feels like a retreat from your household responsibilities while maintaining a professional vibe. Using a rich neutral color for your home office is both relaxing and business-like. In a small home office, light neutral colors with lots of white trim and natural lighting can give the space an expansive look and improve your productivity.
Your small home is the perfect spot for a sunny little kitchen. A warm yellow like Benjamin Moore's Hawthorne Yellow would look great with white cabinets, subway tile walls, and a weathered gray tile floor. The secret to choosing the right yellow paint color for your small kitchen is to sample light yellow colors first, then increase the intensity if you don't get the look you want right away.
Warline Painting is a one-of-a-kind company. Heidi Nyline is an expert in specifying beautiful exterior and interior colors - she is always spot-on! This is the only paint company I know of with the design expertise built right in. If you are looking for painters who go above and beyond to deliver quality and attention-to-detail, hire Warline for your next project!
Do you want painting so beautiful you’ll be itching to show it off? Then choose ProTect Painters! Our team is highly qualified and experienced, and we focus on the customer experience with industry leading standards of service and care. Since our company was founded in 1995, the name Protect Painters been synonymous with good communication, security, quality, respect, and jobs well done. You can rely on us.

An easy way to calculate the square footage of a room, is to measure and add the total length of the all the walls, then multiplying that total by the height of the room. If there are big areas within that space that are not getting painted, it’s a good idea to deduct their square footage from the total. Examples are: a large window wall, double doors, or a wallpapered wall. If two coats are required, the measured square footage is doubled. In a 10 by 14 room the walls have a linear length of 48 feet. Multiplying 48 times 8 (the height of the walls) will give us 384 square feet of paintable wall.

I disagree with your criteria to hire a painter. A prompt returned call is nice but does not indicate the quality or fairness of the painter. As far as a written estimate, that should be more of a qualifier for the bid versus an evaluation criterion. I'm not sure one would have favorable results by hiring a painter on this basis. As far as the bidding process, change orders should ONLY be used if the customer requests additional scope (PMP 101). Angie's list should consider asking reviewers if/how much they were told to pay compared with the estimate. Unfortunately, there are a lot of contractors that are unethical and need to be accountable.


Don't hesitate to ask all the questions you need to feel comfortable hiring a professional. You can also ask 3-4 professionals to make sure you have the right quote in mind. You must make sure they have a warranty or some kind of paperwork stipulating the quality of their jobs. Insurance is also a #1 priority to consider, as damage can happen in the process of painting.

When your brush is loaded with paint, it's easy to create runs by applying too much paint in corners or along trim. To avoid that, start brushing about 1/2 inch away from the cut-in area to apply the paint. As the brush unloads, move over and slowly drag the brush along the trim or corner. Let the bristles gently push the paint against the cut-in area where the walls meet. You may have to do this a couple of times to get complete coverage, but it'll avoid excess paint along woodwork and in corners.
A textured wall will need more paint than a smooth wall. The texture adds more surface area, even though it doesn't increase square footage. Determining the additional surface area depends on how much texture there is. Painters will probably estimate about 300 to 350 additional square feet of paint to account for texture. Factor additional surface area into your square footage calculations when seeking professional estimates.
×